The L42A1 was a British Army, Royal Marines and RAF Regiment sniper rifle chambered for the 7.62×51mm NATO cartridge. It entered service in 1970. The rifle was replaced by the Accuracy InternationalL96 in 1985. The L42A1 was the last model in a long line of Lee bolt-action rifles that used a rear-locking action designed by James Paris Lee for the British Army. This action design appeared first in the Lee–Metford rifle of 1888. During its British Army service, the L42A1 was used in active service in several conflicts, including the Dhofar Rebellion in Oman, The Troubles in Northern Ireland, the Falklands War and Gulf War.

During World War II, the British standardized their sniper equipment as the Lee-Enfield Number 4 Mark I (T). There were three main batches of conversions. RSAF ENFIELD CONVERSIONS  1941 – 1942 – The first batch of conversions. Most of these were 1931 and 1933 dated No. Enfield #4 Front Handguard, 10.75'.NOS. $12.99 As low as $11.50. Enfield #4 / #5 MK 1 Bolt Release Stop Plate, Savage Marked.Good. Cruciform Spike Bayonet w/Scabbard, for British #4 Lee-Enfield Rifle.Very Good. Enfield #4 / #5 Main Spring for Firing Pin,.NOS. Castle defense upgrade hacked. $1.99 As low as $1.65.

Design details[edit]

The L42A1 was a 7.62×51mm NATO conversion of the .303 British chambered Lee–Enfield No. 4 Mk1(T) and No. 4 Mk1*(T) WWII-era British sniper rifles, which had remained in service for some time after the 7.62×51mm NATO chambered L1A1 Self-Loading Rifle replaced the No.4 Lee–Enfield as the standard service rifle in 1957. It differed from other post-war No. 4 based variants in that the trigger remained hinged on the trigger guard as on the No4 Mk1 and 1*, not hung from the receiver as in the later No4 Mk 2, Mk 1/2 and Mk 1/3 .303 British rifles, and other 7.62×51mm NATO conversions. The conversion programme was carried out at Royal Small Arms Factory Enfield from 1970 to 1971. About 1,080 rifles were converted. A new hammer-forged heavy 7.62×51mm NATO barrel was installed, with four-groove, right hand twist rifling instead of the five-groove left-hand Enfield-type rifling used in .303 British barrels. The heavier barrel was free-floating, which meant that the required accuracy standard could be achieved without the barrel bearing against the wooden fore-end, as had been the case with the No.4 MkI(T). Therefore the woodwork was modified by shortening the fore-end to 1/2' in front of the middle band, and a new design upper handguard was fitted. The No. 32 3.5 power telescopic sight was refurbished and the bullet drop compensation on the elevation drum modified for the ballistic characteristics of the 7.62×51mm NATO cartridge in 50 m (55 yd) increments out to 1,000 m (1,094 yd). The modified version was renamed the 'Telescope, Straight Sighting, L1A1'. A new magazine suitable for the 7.62×51mm NATO cartridge was attached; it is recognizable by its more square shape when compared against the .303 British version. A hardened projection of the left magazine lip serves as an ejector, although the .303 ejector screw remained in place. The butt with its screwed-on cheekpiece was retained, however the scope number on the wrist of the stock, was obliterated with 'X'-outs, and new numbers applied. The markings on the left side of the receiver were obliterated and new markings reflecting the new rifle's designation and chambering were applied. The original markings are sometimes partially visible underneath. A new, larger transit case was made for the L42A1.

Variants[edit]

The L39A1 was a target-shooting variant produced for military full-bore shooting teams. It was similar to the L42A1, except it was fitted with Parker-Hale target tunnel front and micrometer-adjustable rear sights in lieu of the telescopic sight, and the butt had a curved pistol grip similar to the butt used on the No.8 .22 rifle. Since magazine loading was not required, the L39A1 had a .303 British magazine, the follower of which served as a loading platform for single shot use. The barrel was the same hammer-forged, heavy 7.62×51mm NATO version fitted to the L42A1.

The Enfield Enforcer was a police-specific sniper variant used by various British police forces from the early 1970s. It was similar to the L39A1, with a shorter style butt with semi-pistol grip and integral cheeckpiece. It was provided with a high-quality East German-made Pecar Berlin telescopic sight. The telescope mounts were of commercial pattern; they did not resemble the No.4 Mk1(T) type screw-on mounts used on the L42A1. Target sights similar to those used on the L39A1 were also fitted to the Enforcer. The 7.62×51mm NATO magazine was fitted, and 767 were made.

Bengali to italian dictionary download full. The Enfield Envoy was similar to the L39A1, but was produced with a higher standard of external finish for sale on the civilian market. It had a fore-end of broader cross section and a sporter style butt.

External links[edit]